I'm planning to deposit a thin layer of a gel (~10 - 100 uM), which will later be heat cured using a spin-coater. I've looked at a few models to predict the thickness of the gel based on experimental parameters (rpm, viscosity, time, etc.) but am still unsure on which model is the best to go with. Some of the papers I've looked at...
1) http://ift.tt/W1BIbb
2) http://ift.tt/W1BIrU
A good amount of the math is too complicated for me, so I'm just looking for an equation/model I can use to predict what experimental parameters I should use to achieve a certain thickness (roughly).
Thank you
1) http://ift.tt/W1BIbb
2) http://ift.tt/W1BIrU
A good amount of the math is too complicated for me, so I'm just looking for an equation/model I can use to predict what experimental parameters I should use to achieve a certain thickness (roughly).
Thank you
0 commentaires:
Enregistrer un commentaire